Engineered Flooring Installation Guide

Never use a water based adhesive to install Engineered Hardwood Flooring.

Engineered flooring installation guide. INSTALLATION GUIDELINES WOOD FLOORING TABLE OF CONTENTS PAGE FORWARD SECTION 1 - GENERAL INFORMATION Chapter 1 Acceptable Jobsite Conditions 1 Chapter 2 Jobsite Checklist 3 SECTION II - PRODUCT INSTALLATION Chapter 3 Solid Parquet Floor 1 Chapter 4 Engineered Floor 9 Chapter 5 Solid Plank Floor 18 Chapter 6 Solid Strip Floor 26 SECTION III - SPECIAL INSTALLATION. Correctly installing the underlay. Preparing your base floor.

Flooring should be delivered and stored at the jobsite for 48 hours prior to installation to allow the product to acclimate from prior transport or storage conditions. Wwwukflooringdirectcouk Engineered Click Installation Engineered flooring with a click installation system can be installed as floating floor which is the most common and DIY friendly installation method because it is the easiest and the. 1Inspect the hardwood flooring in well lighted conditions to ensure proper identification of any potential problems.

If packaging was removed. Carefully inspect the flooring for grade see Hallmark Floors grading. Stapling down your engineered hardwood is a very similar process to nailing it down with a few minor differences.

To prevent damage to the floor finish avoid tapping the face of the board with the rubber mallet. Once you think your floor looks nice and level check over the area with a spirit level. Remove the skirting boards and scrape off any glue or paint using a putty knife.

It is essential that basements and crawl spaces are dry. High quality adhesive with its corresponding vapor reta rder 18-gage ¼ crown staple by 1 ½ long or floating method using recommended tongue and grove adhesive. Laying the wood planks.

When installing on concrete subfloors trowels should be replaced every 3000 ft. Fitting skirting boards and radiator covers. This drastically cuts down the cost and time of installation although you are still required to put in a type of underlay to soften any noises from the floor.